GENERAL SPECIFICATIONS:
PROCESSOR SUPPORT
Supports Pentium M Dothan up to 2.0GHz (socket 478M) with FSB clock cycles @ 400MHz
CHIPSET
Intel® 855GME provides support for Pentium M processor. Intel® 855GME is the Northbridge which includes the Graphics and Memory Controller Hub (GMCH), and the Southbridge is the 82801DBM I/O Controller Hub (ICH4-M). The 855GME controls the graphics controller and PC200/266/333 DDR SDRAM. The 82801DBM controls three USB controllers (six ports USB 2.0), two ATA/100 IDE controllers, LAN interfaces, AC ’97 version 2.3, PCI, super I/O.
HOST BUS INTERFACE
PCI bus supports 32-bit transfers @ 33MHz, via PCI backplane.
FLASH BIOS
AWARD® version 6.0 has built-in advanced CMOS setup for system parameters, peripheral management, PCI-to-PCI bridge support and PCI steering. Supports flash devices for BIOS via EIDE interface or Ethernet. BIOS upgrades are available from the MIS web site.
L-2 CACHE
1MB integrated via CPU
DDR SDRAM MEMORY
Up to 1GB of DDR SDRAM ECC non-registered in one 184-pin DDR DIMM socket (Supports PC2100 / PC2700).
EIDE ULTRA ATA-100 INTERFACES
Two IDE ports available supports up to four IDE devices. First port is the Enhanced IDE with Ultra-DMA 100, supports up to two ATAPI devices via 40-pin Box header. Ultra-DMA transfer rates @ 100MB / 66MB / 33MB per second. Second port is the IDE DMA 33, supports up to two ATAPI devices via 44-pin 2mm Box header. Ultra-DMA transfer rates @ 33MB per second.
WATCHDOG TIMER
256-Level timer (hardware configurable) could be set to automatically detect software anomalies and reset the processor by a predetermined time constant, enabling the system to recover from transient failures.
REAL TIME CLOCK
Incorporated in chipset with 10years of CMOS backup via lithium battery, backup includes BIOS setup and BIOS default.
NETWORK CONTROLLER
CHIPSET
SBC-5643N: Dual Intel® 82562ET PHY @ 10Mbps / 100Mbps, auto-switching
SBC-5643NG: Intel® 82562ET PHY @ 10Mbps / 100Mbps, Intel® 82541G1 @ 10Mbps / 100Mbps / 1Gbps auto-switching
LAN INTERFACES
Two on board RJ-45 connectors
DISPLAY CONTROLLER
CHIPSET
Intel® 855GME 82815 integrated graphic, supports 4x AGP.
DISPLAY MEMORY
Up to 64MB of shared DDR SDRAM memory
DISPLAY TYPES
CRT, Flat Panel
CRT RESOLUTIONS
Maximum resolution 1024 x 768 @ 32bpp (XGA, SVGA, VGA)
CRT INTERFACE
On board DB-15 connector
FLAT PANEL RESOLUTIONS
Maximum resolution 1600 x 1200 @ 24bpp (UXGA, SXGA, XGA, SVGA, VGA)
FLAT PANEL INTERFACES
On board TTL via 40-pin DF-13 connector and On board LVDS via 30-pin DF-13 connector
AUDIO CONTROLLER
CHIPSET
Southbridge ICH4 with AC97 digital audio controller, direct sound ready
AUDIO INTERFACES
Line-in, MIC, speaker out via 10-pin 2mm Box header
FLASH DISK SUPPORT
COMPACT FLASH
Supports type I & type II compact flash disks with capacities up to 1GB via compact flash socket on rear side of SBC-5643
DISK-ON-MODULE®
One module via EIDE 40-pin Box header with capacities available up to 512MB
HIGH SPEED MULTI I/O
CHIPSET
Intel I82801DBM (ICH4-M)
SERIAL PORTS
One high speed RS-232C port COM 1 and one RS-232C / 422 / 485 (jumper selectable) COM 2 via two 10-pin 2mm Box headers. Supported by 16C550 UART and 16KB FIFO
USB INTERFACES
Six USB 2.0 ports via three 10-pin 2mm headers
SERIAL INFRARED INTERFACE (SIR)
IrDA TX/RX port via 5-pin header
FLOPPY DISK DRIVE INTERFACE
Supports 5¼inch (1.2MB / 360KB) and 3½inch (2.88MB / 1.44MB / 720KB) floppy disk drives via 34-pin 2mm Box header (up to two floppy disk drives)
BI-DIRECTIONAL PARALLEL PORT
Supports SPP, EPP and ECP modes via 26-pin 2mm Box header
KEYBOARD / MOUSE INTERFACE
External PS/2 keyboard / mouse port via two-in-one mini DIN, internal AT keyboard port via 5-pin Box header.
POWER ENVIRONMENTAL
POWER REQUIREMENTS
+5VDC @ 3.6A nominal, +3.3VDC from onboard connector (Tested with Pentium M @ 1.1GHz)
BOARD DIMENSIONS
185mm x 122mm (7.3inch x 4.8inch)
BOARD WEIGHT
0.6kg (1.32lbs)
OPERATING TEMPERATURE
0° to 60°C (32° to 140°F)
