|
|
|
|
• On Board Compact Flash Socket Type I/II
• Four Full Size 32-bit PCI Slots
• LVDS flat panel displays
• PS/2 Keyboard/Mouse
• NTSC/PAL TV Output
• Disk-On-Chip® 2000
• Three 16 ISA Slots
• One Ethernet LAN
• Audio Connectors
• One Parallel Port
• Four Serial Ports
• Four USB Ports
• CRT Connector
• Digital I/O
|
DESCRIPTION:
The ETX-8371 is an ETX carrier board with ATX form factor. The board contains four 32-bit PCI slots, three 16-bit ISA slots, two EIDE Box headers, compact flash socket type I/II, Disk-On-Chip® 2000, parallel port, four serial ports, four USB ports, Ethernet LAN, audio connectors, keyboard, mouse, 16-bit digital I/O, CRT connector, LVDS flat panel displays, along with an output for NTSC / PAL compatible television.
GENERAL SPECIFICATIONS:
HOST BUS INTERFACES
PCI Bus supports 32-bit transfers @ 33MHz via four full size PCI slots and ISA Bus supports 16-bit transfers @ 8.3MHz via three ISA slots
EIDE INTERFACES (DUAL)
PCI Enhanced IDE with Ultra DMA 100 supports two ports and up to four ATAPI devices via two 40-pin Box headers
REAL TIME CLOCK
CMOS clock with 10Years of backup via lithium battery, including BIOS setup and BIOS default.
NETWORK
LAN INTERFACE
One on board RJ-45 connector
DISPLAY
DISPLAY TYPES
CRT, Flat Panel, TV-Output
CRT INTERFACE
One on board DB-15 connector
FLAT PANEL INTERFACE
LVDS via 30-pin Hirose connector
TV-OUT INTERFACE
6-pin Box header
AUDIO
AUDIO INTERFACES
Line-in, MIC, and speaker out via three 1/8inch RCA jacks
FLASH DISK SUPPORT
COMPACT FLASH INTERFACE
On board compact flash socket type I/II, up to 1GB
DISK-ON-CHIP®2000
Single chip flash disk in 32-pin DIP JEDEC, up to 576MB
DISK-ON-MODULE®
Up to two modules via EIDE two 40-pin Box header (up to 512MB per module)
HIGH SPEED MULTI I/O
CHIPSET
Winbond 83977EF
SERIAL PORTS
Four high speed RS-232C ports: COM 1, COM 2, COM 3 & COM 4. COM 1 via on board DB-9 connector. COM 2, COM 3 & COM 4 via three 10-pin 2mm headers.
USB INTERFACES
Four USB ports total. Two on board USB ports and two USB ports via 10-pin 2mm headers.
FLOPPY DISK DRIVE INTERFACE
FDD via 34-pin Box header
BIDIRECTIONAL PARALLEL PORT
LPT1 via on board DB-25
SIR INTERFACE
Infrared (IR) via 5-pin header; IrDA ver. 1.1
KEYBOARD / MOUSE INTERFACES
External PS/2 keyboard and PS/2 mouse ports via two mini DIN connectors
DISCRETE DIGITAL I/O
GPIO INTERFACE
Eight independent digital inputs and eight independent digital outputs software programmable
POWER / ENVIRONMENTAL
POWER INTERFACES
ATX via 20-pin with 3-pin ATX control
AT via 12-pin connector
Selectable through BIOS
POWER SWITCHES
One ATX power switch (momentary switch)
One reset switch (momentary switch)
BOARD DIMENSIONS
300mm x 210mm (12inch x 8.25inch)
BOARD WEIGHT
0.51kg (1.12lbs)
OPERATING TEMPERATURE
0° to 60°C (32° to 140°F)
|
|
