GENERAL SPECIFICATIONS:

PROCESSOR
Embedded low power ZF Micro Solutions^® ZFx86 FailSafe™ processor (586 CPU core) supporting CPU clock cycles @ 133_MHz (over-clock mode), 100_MHz (default), 66_MHz and 33_MHz (jumper selectable). On board the ZFx86 resides the Northbridge and Southbridge supporting 32-bit PCI transfers @ 33_MHz version 2.1 compliant. A fail-safe internal boot ROM allowing execution of multiple instruction sets (DRAM clear, flash erase, executable load and run) which provides a permanent and fail-safe mechanism.

FLASH BIOS
Phoenix Embedded PC BIOS with RS-232C console redirection for headless BIOS access. Supports flash devices for BIOS via EIDE interface or Ethernet. BIOS upgrades are available from the MIS web site.

DRAM MEMORY
64_MB of on board embedded SDRAM with one 168-pin DIMM sockets for an additional 128_MB of SDRAM (total of 192_MB of PC66)

HOST BUS INTERFACE
16-bit ISA @ 8.3_MHz, 16-bit PC/104 @ 8.3_MHz

EIDE ATA-66 INTERFACES (DUAL)
PCI Enhanced IDE with DMA 66, supports up to four ATAPI devices. Ultra DMA transfer rates @ 66_MB / 33_MB per second via two 40-pin Box headers

WATCHDOG TIMER
256-Level timer (hardware configurable) could be set to automatically detect software anomalies and reset the processor by a predetermined time constant, enabling the system to recover from transient failures.

REAL TIME CLOCK
Incorporated in chipset with 10_Years of CMOS backup via lithium battery Backup includes BIOS setup and BIOS default.

NETWORK CONTROLLER

CHIPSET
Realtek^® RTL8139C 10_Mbps/100_Mbps, auto-switching

LAN INTERFACE
One External RJ-45 connector on SBC I/O plate

DISPLAY CONTROLLER

CHIPSET
SMI^® LynxEM4+ SM712G4AA

DISPLAY MEMORY
4_MB SDRAM on die

DISPLAY TYPES
CRT, Flat Panel

CRT RESOLUTIONS
Maximum resolution 1280 x 1024 @ 24bpp (SXGA, XGA, SVGA, VGA)

CRT INTERFACE
On board DB-15 connector

FLAT PANEL RESOLUTIONS
Maximum resolution 1024 x 768 @ 24bpp (XGA, SVGA, VGA)

FLAT PANEL INTERFACE
24-bit TTL via 34-pin 2_mm Box header

FLASH DISK SUPPORT

DISK-ON-CHIP^® 2000
On board single chip flash disk socket in 32-pin DIP JEDEC, with capacities up to 576_MB

DISK-ON-MODULE^®
Supports up to two modules via two EIDE 40-pin Box header with capacities available up to 512_MB per module

HIGH SPEED MULTI I/O

SERIAL PORTS
One external high speed RS-232C port COM 1 via on board DB-9 connector, three internal RS-232C ports COM 2, COM 3 and COM 4 via three 10-pin 2_mm Box headers. COM 2 is RS-232C / 422 / 485 (jumper selectable). Supported by 16C550 UART and 16_KB FIFO.

USB INTERFACE
Two USB 1.0 ports via 10-pin header

SERIAL INFRARED INTERFACE
IrDA TX/RX port @ 115_Kbps via 5-pin header

FLOPPY DISK DRIVE INTERFACE
FDD via 34-pin Box header; Supports 5¼_inch 1.2_MB/360_KB and 3½_inch 2.88_MB/1.44_MB/720_KB floppy disk drives (up to two floppy disk drives)

BIDIRECTIONAL PARALLEL PORTS
Two parallel ports via two 26-pin 2_mm Box headers. Supports SPP, EPP and ECP modes.

KEYBOARD / MOUSE INTERFACE
External PS/2 keyboard / mouse port via two-in-one mini DIN, and AT keyboard port via 5-pin Box header

OS SUPPORT
Microsoft Windows^TM (9X, NT, CE) DOS, Linux, WindRiver VxWorks^TM and RTOS.

DISCRETE DIGITAL I/O

GPIO INTERFACE
Eight independent digital inputs and eight independent digital outputs software programmable

POWER / ENVIRONMENTAL

POWER REQUIREMENTS
133_MHz (over-clock mode) +5_V @ 1.1_A nominal
100_MHz (default) +5_V @ 0.9_A nominal
66_MHz +5_V @ 0.8_A nominal
33_MHz +5_V @ 0.8_A nominal
Tested with embedded 64_MB SDRAM and 8_MB of flash disk

BOARD DIMENSIONS
185_mm x 122_mm (7.28_inch x 4.81_inch)

BOARD WEIGHT
0.24_kg (0.52_lbs)

OPERATING TEMPERATURE
0° to 60°_C (32° to 140°_F)